At some point, every skateboarder will need to remove the bearings from their wheels. There are a few reasons why you might need to do this, such as cleaning the bearings or changing out the wheels.
Luckily, it’s a relatively easy process that only requires a few tools. The first step is to remove the axles from the best skateboard deck. Once the axles are removed, you can simply pull the bearings out of the wheels. Next, you’ll need to remove the spacers from the bearings.
How to Get Bearings Out of a Skateboard Wheel
Tools and materials required
- -A hammer
- -A screwdriver
- -A chisel
- -A pair of pliers
- -A vise
- Skate tool
- Bag or small container
- 1/2-inch socket wrench
- Truck axle
- Face mask
A short Result Oriented Procedure
If you’re having trouble getting your bearings out of your Skateboard wheel, here are a few tips that might help.
Bearings are very important in a skateboard wheel. The bearings provide frictionless rotation of the wheel on the axle. You need to replace your bearings when they start to get worn down and not rotate as smoothly. Here is a step-by-step guide on how to replace the bearings in a skateboard wheel:
1) Remove the old bearings from the wheel. You can do this by using a bearing puller or by prying them out with a flathead screwdriver. Be careful not to damage the axle in the process.
2) Clean out the axle holes with a rag to remove any dirt or debris. This will help ensure that the new bearings fit snugly in place.
3) Place the new bearings on the axle and press them into place. Again, be careful not to damage the axle.
4) Re-install the skateboard wheel onto the right size deck and you’re done! Your skateboard should now rotate more smoothly than ever before. Thanks for following our step-by-step guide!
Step I: Remove the wheels
Whether you’re a beginner or a seasoned veteran, there may come a time when you need to replace the bearings in your skateboard wheels. The good news is that this is a relatively straightforward process that anyone can do at home with a few basic tools. The first step is to remove the wheels from the best pop skateboard. This can be done by unscrewing the bolts that hold them in place. Once the wheels are off, you’ll need to remove the bearings from each wheel. To do this, simply pop out the bearing caps and then press the bearings out from the inside of the wheel. With the bearings out, you’re now ready to clean and lubricate them before putting them back in place.
Step II: Hook on the Truck Axle
The second step for bearings out of a skateboard wheel is to hook on the truck axle. This can be done by using a rubber band or by tying a string around the axle. Once the axle is secure, the next step is to place the bearing on the axle. The third step is to secure the bearing by using a washer and a nut. The fourth step is to tighten the nut until the bearing is snug against the washer. The fifth and final step is to test the bearings by spinning the wheel. If the bearings are tight and spin smoothly, then they are ready to be used on a skateboard.
Step III: Pry off the Bearing
The third step for bearings out of a skateboard wheel is to pry off the bearing. Bearings are small, round metal pieces that fit snugly into the center of each wheel. They help the wheels to spin smoothly and quietly. To remove the bearings, use a flathead screwdriver to pry them out of their seats. Be careful not to damage the bearing seats as you remove them. Once all four bearings have been removed, you can proceed to the next step.
Now that you know how to replace the bearings in a skateboard wheel, you can keep your skateboard running smoothly for years to come. Remember to be careful when removing the old bearings and installing the new ones.